PLEASE NOTE BEFORE APPLYING PRODUCT
• Bovi-Bond is most easily used between 65° and 85° F (18° to 29° C). Temperature will affect the set time.
See Cold & Hot Conditions below.
• Areas of wetness, bleeding or infection should not be covered. Once healed, commence using Bovi-Bond.
COLD CONDITIONS (Below 65° F)
• Do not microwave the cartridge or place it in water.
• Heat the block with a heat gun for 10 seconds.
• Keep cartridges and blocks warm. Tip: Keep both in an
insulated "cooler" with microwaveable heat pads or
1 to 2 tightly capped gallon jugs filled with hot water. The material will dispense easily and set normally.
• Keep the hoof off the ground one extra minute.
HOT CONDITIONS (Above 85° F)
• Product will set very quickly. To slow the set time, if needed store the material in an insulated cooler with 1 or 2
freezer packs.
• NOTE: During hot weather conditions, product may cure at a higher temperature. If applying close to sensitive
tissue, product may be applied in layers to reduce heat.
CARTRIDGE PREPARATION
1. To open the cartridge, cut the tip at line with sharp nippers. Insert cartridge into dispensing gun, label side up.
2. Before attaching the mixing tip, equalize the cartridge by squeezing out a small amount to ensure that both
sides are dispensing evenly.
3. Use only Vettec mixing tips. Attach a mixing tip by pressing and twisting clockwise.
4. When finished, do not release the pressure with the lever on the back of the dispenser. Remove the mixing
tip immediately, discard and apply the cap. The pressure can now be released. Extra caps are available from
your dealer, if needed.
5. For additional applications, re-equalize the cartridge and attach a new tip.
HOOF PREPARATION
1. Trim, rasp, or grind to balance claw, as level as possible. Sand and clean thoroughly.
2. DRY claw with a heat gun.
APPLICATION PROCEDURE
1. Heat the block with the heat gun for 10 seconds in cold weather.
2. Rapidly dispense Bovi-Bond directly onto the block in a strip about 3/4 to 1 inch wide. This varies with the
shape of the claw. Option: Bovi-Bond can be applied on either the block or the hoof.
3. Immediately press the block gently onto the clean, dry claw and hold for 20 seconds. Don't express all the
glue. Leave about 1/8 inch, or 2-3 mm, of material between the block and the claw or hoof for faster,
harder set.
4. Material should be HARD and weight bearing in approximately 2-3 minutes.
  
Download Instruction PDF: English | Spanish
For professional use only. Keep out of reach of children.
|
